HESS Hydraulic Equipment Systems and Solutions

Гидравлическое Оборудование Системы и Решения

img
img

Обратная связь

ФИО* e-mail* Телефон* Организация Содержание запроса* Прикрепить файл Выберите файл Введите число с картинки* поменять картинку

Каталог продукции

Бренды

Clamping and drive modules UPE 2

min-slider-1

Clamping and drive modules UPE 2

  • Drive power 1.1 kW / 2.2 kW
  • Component series 1X
  • Maximum operating pressure 700 bar
  • Duty cycle, short-time operation S2 and intermittent operation S3
  • Compact design
  • Low noise
  • Wide field of application
  • Large number of variants
  • Complete hydraulic control possible
  • Ready for connection

Hydraulic fluid 1)

Mineral oil (HLP) to DIN 51524-2

Hydraulic fluid temperature range

°C

-20 … +80

Maximum admissible degree of contamination of the hydraulic fluid, cleanliness class according to ISO 4406 (c) 2)

Class 20/18/15 according to ISO 4406 (c)

Optimum viscosity range

mm²/s

10 … 200

Direction of rotation

any (radial piston pump), clockwise (external gear pump)

Installation position

Vertical

Operating mode

All operating modes with which the steady-state oil temperature remains below 80 °C.

Protection class according to VDE 0530/EN 60034

IP54 with completely mounted power unit

Tank size

3/R 4/R 4/G 5/R 7/R 7/G

Weight 3)

kg

17.8 18.4 19.6 23 25 26.6
1) Please observe our provisions according to data sheet 07075!
2) The cleanliness classes specified for the components must be adhered to in hydraulic systems. Effective filtration prevents faults and simultaneously increases the life cycle of the components. For the selection of the filters, see www.boschrexroth.com/filter.
3) Without hydraulic fluid

The UPE 2 clamping and drive module constitutes a complete drive system which is delivered ready for connection. It is used for the hydraulic fluid supply of hydraulic circuits.

For reasons of thermal loading, the clamping and drive module is to be operated in short-time operation and intermittent operation. The duty cycle is to be selected dependent on the power output and the environmental conditions so that the maximum admissible operating temperature of 80°C is not exceeded.

The clamping and drive module basically consists of the aluminum housing, the pump (radial piston pump or external gear pump) and the oil-immersed motor. The stator of the oil-immersed motor is pressed into the aluminum housing. It leads the winding heat directly to the exterior wall of the aluminum housing.

For the installation, four through holes for the mounting screws have been provided in the tank bottom. The clamping and drive module is to be operated in vertical installation position.
 

Optionally, the UPE 2 clamping and drive module can be equipped with an electric oil level and oil temperature monitoring, a breathing filter and a complete hydraulic control (see 51144).

Вернуться на уровень выше