Бренды
Control modules IH15BB
Control modules IH15BB
-
Component series 1X
-
Maximum operating pressure 350 bar
-
Maximum flow 30 l/min
- Compact design
- No piping of the control
- Few joints
- Variable set-up
- Can be combined individually
- Direct mounting on power unit tank cover; external set-up possible, as well
- Ready for connection
|
Installation position 1) |
any | |||
|
Hydraulic fluid 2) |
Suitable for NBR and FKM seals: Mineral oil (HL, HLP) according to DIN 51524 part 2, fast bio-degradable hydraulic fluids according to VDMA 24568 (see 90221); HETG (rape seed oil); Suitable only for FKM seals: HEPG (polyglycols); HEES (synthetic esters) |
|||
|
Hydraulic fluid temperature range 3) |
°C |
-30 … +80 | ||
|
Ambient temperature range |
°C |
-30 … +50 | ||
|
Viscosity range 1) |
mm²/s |
2,8 … 500 | ||
|
Maximum admissible degree of contamination of the hydraulic fluid, cleanliness class according to ISO 4406 (c) 1) |
Class 20/18/15 according to ISO 4406 (c) | |||
|
Valve pressure rating |
Refer to the related data sheet | |||
|
Maximum flow of the directional seat valves type: KSDR1... |
2/2 directional seat valve |
qV |
l/min |
20 |
|
3/2 directional seat valve |
qV |
l/min |
12 | |
|
Voltage type |
Direct voltage | |||
|
Available voltages 4) |
U |
V |
24 | |
|
Voltage tolerance (nominal voltage) |
% |
± 10 | ||
|
Power consumption 1) |
P |
W |
19 | |
|
P |
W |
30 1) | ||
|
Switching time according to ISO 6403 |
ON |
T |
ms |
25 … ≤80 |
|
OFF |
T |
ms |
10 … 25 | |
|
Switching frequency |
up to 15,000 switching cycles per hour | |||
|
Protection class according to DIN EN 60529 (VDE 0470-1), DIN 40050-9 5) |
IP65 | |||
|
Coil temperature 6) |
°C |
150 | ||
The IH15B control modules serves the realization of complete hydraulic controls. They can be fitted and mounted individually. The directional valve modules and seat valve modules can be combined.
Using the tank connection modules, the control modules can be directly mounted to the tank cover of the oil tank. Using the modules for external attachment, the control modules can, however, also be installed arbitrarily into every system. The reducing modules allow for attachment of the IH15B modules to IH15A and IH20B modules.
The modules have preferably been designed for hydraulic controls for low-flow actuators up to a flow of 30 l/min. They are connected by means of three tie rods.