HESS Hydraulic Equipment Systems and Solutions

Гидравлическое Оборудование Системы и Решения

img
img

Обратная связь

ФИО* e-mail* Телефон* Организация Содержание запроса* Прикрепить файл Выберите файл Введите число с картинки* поменять картинку

Каталог продукции

Бренды

Inline filter with filter element according to Bosch Rexroth standard 16 FE

min-slider-1

Inline filter with filter element according to Bosch Rexroth standard 16 FE

  • Size 2500 … 7500
  • Max. operating pressure 16 bar
  • Flow, max. 11800 l/min
  • Port SAE 2 1/2", 3000 psi, DN150, DN150, DN200, DN200, DN250, DN250, DN300
  • Operating temperature -10 … +100 °C
  • Filter for inline installation, return flow or bypass with several filter elements in the filter housing
  • Special highly efficient filter media
  • Filtration of very fine particles and high dirt holding capacity across a broad pressure differential range
  • High collapse resistance of the filter elements
  • Optionale Ausführung mit mechanisch-optischer Wartungsanzeige mit Memoryfunktion
  • Optional equipment with various electrical switching elements, modular design
  • Optionale Bypassventile in den Filterelementen integriert

Size

2500 3000 4000 4500 6000 6500 7000 7500

Installation position

    vertical   vertical   vertical

Ambient temperature range

ϑ

°C

-10 … +65   -10 … +65   -10 … +65

Weight

m

kg

104 108 140   168   333 355

Volume

 

l

51 53 94   149   335 344

Material

Filter cover

    Steel

Filter housing

    Steel

Bypass valve

    Steel/plastic

Seals

    NBR / FKM

 

The 16 FE inline filter is suitable for inline installation.

It basically consists of filter housing (1), a filter cover (2), several filter elements (3) as well as mechanical/visual maintenance indicator (4) and an optional cover lift-off device (5).

Via the inlet, the fluid reaches the filter elements (3) where it is cleaned. The dirt particles filtered out settle in the filter elements (3). There is an indirect flow to the filter elements.

Via the outlet, the filtered fluid enters the hydraulic circuit.

The filter housing and all connection elements are designed so that pressure peaks – as they may e.g. occur in case of abrupt opening of large control valves due to the accelerated fluid quantity – can be securely absorbed. For all sizes, the standard equipment comprises a bleed screw (6) and a drain screw (7).

Instead of a bleed screw, an optional bleed valve (6) – supplementary information E –  is possible.

 

For integration of the maintenance indicator into an electric circuit, the mechanical/visual maintenance indicator may be amended by an electronic switching element. To this end, the electronic switching element (8) must be attached to the mechanical/visual maintenance indicator (4) and held by means of a locking ring. The electronic switching elements are connected via a mating connector or a cable connection.

The electronic switching element must be ordered separately.

Warning:

If the maintenance indicator for the element exchange is not observed, the optional bypass valves will open if the pressure differential increases. In this way, one part of the flow reaches the clean side of the filter without being filtered. Thus, effective filtration is no longer guaranteed.

Вернуться на уровень выше