Бренды
Replacement cartridge filter 7 SL
Replacement cartridge filter 7 SL
-
Size 30/21, 45/21, 60/21, 90, 130, 180, 260
-
Max. operating pressure 7 bar
-
Flow, max. 300 l/min
-
Port G3/4, G1 1/4, G1 1/2
- Filters for inline installation
- Special highly efficient filter media
- Filtration of very fine particles and high dirt holding capacity across a broad pressure differential range
- Optionale Ausführung mit Wartungsanzeige, Manometer oder Vakuummeter
- Optional bypass valve integrated in the filter housing
- Installation in suction, pressure and return lines possible
- Optimiert für Mobilhydraulik, platzsparend und servicefreundlich
|
Size |
30/21 | 45/21 | 60/21 | 90 | 130 | 180 | 260 | |||
|
Installation position |
Vertical | |||||||||
|
Port |
G3/4 | G1 1/4 | G1 1/2 | |||||||
|
Ambient temperature range |
ϑ |
°C |
-40 … +65 | |||||||
|
Weight |
m |
kg |
0.8 | 0.9 | 1.1 | 1.6 | 1.9 | 3 | 3.2 | |
|
Volume |
l |
0.5 | 1.2 | 2 | 2.7 | 2 | 2.7 | |||
|
Material |
Filter head |
Aluminium | ||||||||
|
Seals |
NBR | |||||||||
General information:
The replacement cartridge filter is suitable for direct installation in suction, pressure or return lines. It is installed upstream components to be protected.
It basically consists of a filter head (1) and a screwed replacement cartridge (2) with integrated filter element (and/or two replacement cartridges for size 180 and 260).
Optionally, a maintenance indicator (3) and/or a bypass valve (4) are configurable for the filter.
Via the inlet, the fluid reaches the replacement cartridge (2) where it is cleaned. The dirt particles filtered out settle in the filter element. Via the outlet, the filtered fluid enters the hydraulic circuit. With sizes 180 and 260, there is simultaneous flow through both replacement cartridges.
Maintenance indicator:
Special maintenance indicators are possible for the following applications:
The relevant position of the maintenance indicator is shown in chapter “Dimensions”.
Notice:
If the maintenance indicator for the replacement cartridge exchange is not observed, the bypass valve will open if the pressure differential increases. In this way, one part of the flow reaches the clean side of the filter without being filtered. Thus, effective filtration is no longer guaranteed.